SipDeviceConfiguration » History » Revision 51
Revision 50 (Adrian Georgescu, 01/25/2012 01:11 PM) → Revision 51/109 (Adrian Georgescu, 01/25/2012 01:11 PM)
h1. = Device Configuration = [[TOC(WikiStart, Sip*, depth=3)]] There are thousands of SIP devices on the market, for how to configure them we advise you to consult the support forum of the device manufacturer. Please do not open a ticket related to how a particular device must be configured. Setup your SIP device as follows: h2. == Account Credentials == Account credentials are used for authentication and authorization of SIP requests performed by the SIP device. | Username| XXX| || Username|| XXX|| | Password| YYY| || Password|| YYY|| | !Domain/Realm|sip2sip.info| || !Domain/Realm||sip2sip.info|| * Always Register must be On * Set the Registration refresh interval to 600 seconds * There are multiple servers available in multiple locations. To locate them, the SIP device must always perform DNS lookups as defined in SIP standard RFC3263. [[SipDevices|Specific [wiki:SipDevices Specific SIP devices configuration]] h2. configuration] == Outbound Proxy == The following details may change over time, please use DNS lookups instead of hardwiring these setting into your SIP device. | || Host | || Port | || Protocol | || | proxy.sipthor.net| 5060| || proxy.sipthor.net|| 5060|| UDP | || | proxy.sipthor.net| 5060| || proxy.sipthor.net|| 5060|| TCP | || | proxy.sipthor.net| 5061| || proxy.sipthor.net|| 5061|| TLS | h2. || == XCAP Root == If you use SIMPLE presence you need to set XCAP root: | || XCAP Root | || https://xcap.sipthor.net/xcap-root@sip2sip.info/ | h2. || == MSRP Relay == If you use SIMPLE instant messaging based on MSRP, a relay is available for helping traverse the NAT. You need to use the relay if you are the receiving party and you are behind a NAT-ed router. The MSRP relays can be found in the DNS by using SRV lookup for _msrps._tcp.sip2sip.info.